8.3.11. Removal of the module of the passenger airbag (PAB)

Removal

NOTE
Do not sort and do not repair the safety cushion module.
Do not drop the block, do not allow pollution of the module water, oil or lubricant. Replace the module in the presence of dents, cracks, deformations or a rust.
The module of a pillow has to be stored on a flat surface by a slip up. Do not put any objects on an overlay of a pillow.
Do not allow heating of the module of a pillow over 93 °C.
Blasting and utilization of a pillow have to be carried out according to the special procedure.
Never try to measure pillow electrofuse resistance, even by means of a special tester: sudden blasting a pillow which will lead to accident is possible.
If the pillow worked, the module of a pillow has to be replaced with new.


Disconnect a wire from the negative plug of the rechargeable battery.

ATTENTION
Before works make a pause not less than 30 pages.

Remove a ware box.
Disconnect the socket of the module of the passenger airbag.
Remove the forward panel and remove the module of the passenger airbag.
The upholstery of the module of the passenger airbag is combined with an upholstery of the forward panel. Therefore when blasting a pillow the forward panel has to be replaced.