8.2.7. Removal and installation of glass of a door of a back

Fig. 8.38. Back door glass


Fig. 8.39. Socket of wires of an element of heating of back glass

Disconnect the socket of wires of an element of heating of back glass (fig. 8.39).
Remove facing of a door of a back.
Remove the lever and the electric motor of a screen wiper.
Remove an additional stoplight.

The procedure is identical to removal of back and wind glasses.

By means of a cutting torch or adaptation 09861-31200 exactly cut off the glue roller to thickness about 2 mm from the surface of gluing of glass on all perimeter of a flange of an aperture.

Do not cut off the glue roller to thickness, it is less specified, and take precautionary measures not to damage a paint and varnish covering of a body a cutting torch. At damage restore a layer, having applied finishing paint.

Clear a flange of an aperture of back glass the sponge impregnated with alcohol or means for removal of mastics and degreasing.
Establish new back glass in an aperture and apply with a soft pencil tags on glass and a body in four places.
Establish an overlay of back glass, watching that there were no gaps.
Apply a thin film of glue soil for glasses on an edge of back glass.

Fig. 8.40. Scheme of putting sealant

Apply sealant on an edge of glass (fig. 8.40).
Apply a thin film of glue soil for a body on the sealant layer left on a glass aperture flange. After putting glue soil establish glass not later than in 5 min.
By means of suckers 09861-31400 impose back glass on an aperture, combining the put tags, and press glass to a sealant layer.
Remove surplus of glue with the pallet or erase it a gauze. Fill with glue all emptiness on glass perimeter.
Be convinced of tightness of a windshield for what water it with a stream of cold water, watching that a strong stream not to damage a fresh glue layer. Water so that water flew down on glass edges.
At detection of leakages dry the place of a leakage and apply sealant.
Establish earlier removed details.