6.1.5. Removal and installation of the vacuum amplifier of brakes

Fig. 6.9. Vacuum amplifier of brakes



Removal
Disconnect a brake tube from the main brake cylinder.

Fig. 6.10. Nuts of fastening of the main brake cylinder


Remove the main brake cylinder (fig. 6.10).

ATTENTION
At hit of brake fluid on the painted surfaces immediately wipe the spilled liquid.

Disconnect a vacuum hose from the amplifier of brakes.
Disconnect a pusher of the amplifier of brakes from a brake pedal.

Fig. 6.11. Nuts of fastening of the vacuum amplifier of brakes


Turn off nuts of fastening of the vacuum amplifier of brakes (fig. 6.11).
Lift the vacuum amplifier of brakes assembled and remove him.

Installation
Before installation of the vacuum amplifier of brakes assembled check a condition of both laying of its arm of fastening, if necessary replace laying.
Establish the vacuum amplifier of brakes into place and tighten fastening nuts.
Inhaling moment: 13–16 N · m.
Put enough jellied lubricant in a brake pedal lever opening (a pin installation site).

Fig. 6.12. Connection of a fork of a pusher


Connect a pusher fork to the brake pedal lever by means of a pin with an opening under the forelock and record a pin the forelock (fig. 6.12).
Install the main brake cylinder. also connect to it a brake tube.
Connect a vacuum hose to the amplifier of brakes.
Fill with brake fluid a tank of a hydraulic system of brakes.
Be convinced of lack of leak of brake fluid.
Check and adjust the provision of a pedal of a brake.

Fig. 6.13. Places of putting jellied lubricant


After installation of details put enough jellied lubricant in places of contact of a fork of a pusher and pedal of a brake (fig. 6.13).