6.1.14. Removal, check and installation of the parking brake

Fig. 6.54. Contour of the parking brake



Removal
Remove the back console.

Fig. 6.55. Adjusting nut of the lever of a cable of the parking brake


Weaken an adjusting nut and disconnect a cable of the parking brake (fig. 6.55) from the lever.
Remove the switch of a control lamp of the parking brake.
Remove the lever of the parking brake assembled.
Remove a back wheel.
Remove the brake drum.
Remove brake shoes.

Fig. 6.56. A cable detachment from a block of the parking brake


Disconnect a cable from a block of the parking brake (fig. 6.56).

Fig. 6.57. A ring of fastening of a cable to a basic brake disk


Remove a ring of fastening of a cable to a basic brake disk (fig. 6.57).

Fig. 6.58. Fastening of clips of fixing of cables of the parking brake


Turn off bolts of fastening of clips of fixing of cables of the parking brake, remove cables assembled (fig. 6.58).

Check
Check operability of the switch of a control lamp of the parking brake.
Check a condition of a ratchet of the lever of the parking brake.
Estimate a condition of cables of the parking brake.

Installation

Fig. 6.59. Color tag of cables of the parking brake


Check color identification tags of cables of the parking brake. Connect cables according to tags (fig. 6.59).

Identification tag
Left side: red.
Right side: yellow.

Fig. 6.60. Top returnable spring


At installation of the top returnable spring remove the regulator lever (fig. 6.60) back.

Fig. 6.61. Fastening of cables of the parking brake


Fix cables of the parking brake, as shown in the figure 6.61.
Grease a ratchet and a doggie of the lever of the parking brake with jellied lubricant.
Install the regulator of cables and adjust cables of the drive of the parking brake.

NOTE
The parking brake has to work at the eighth click of a ratchet of the lever of the parking brake at the effort of 196 N made for the point of the lever located at distance of 40 mm from the end of the lever.