5.1.10. Check of steering with the amplifier

Be convinced of lack of cracking of hoses, slightly twisting them a hand.
Be convinced of lack of traces of contact of hoses with car details.

Filling of a hydraulic system of the amplifier of steering with working liquid
Fill a tank of a hydraulic system of the amplifier of steering with the recommended liquid to a tag "MOVE" on a tank wall.
By means of a jack you will hang out forward wheels of the car. Disconnect wires of high voltage from ignition coils. Scroll a bent shaft of the engine several short-term inclusions of a starter (about 5-6 inclusions) at continuous turns of a steering wheel to the left and to the right against the stop five or six times during 15–20 pages.
Connect wires of high voltage to ignition coils, then start the engine and leave it to idle. Turn a steering wheel from an emphasis against the stop before disappearance of vials of air in a tank of a hydraulic system of the amplifier.
Make sure that working liquid is transparent, without turbidity, and its level is in a tank about the mark "MAH" in a tank wall.

ATTENTION
If liquid level considerably changes at turn of a steering wheel or sharply increases after an engine stop, air from a hydraulic system means it is removed not completely. Incomplete removal of air from a hydraulic system of the amplifier will lead to emergence of extraneous noises and reduction of service life of the pump and other elements of a hydraulic system of the amplifier.