4.3.2. Removal and check of the longitudinal lever of a back suspension bracket
Fig. 4.51. Longitudinal lever of a back suspension bracket
|
Removal
Fig. 4.52. Cable of the parking brake
|
Disconnect a cable of the parking brake from an arm of the longitudinal lever of a back suspension bracket (fig. 4.52).
Fig. 4.53. Bolt of fastening of the cross lever of a suspension bracket
|
Turn off a bolt of fastening of the cross lever of a suspension bracket to a fist of a back wheel (fig. 4.53).
Support a back cross beam, having established a jack under its central part, then turn off bolts of fastening of a cross beam to a body.
Remove a back cross beam together with cross levers of a suspension bracket.
Replacement of the plug of the longitudinal lever
Fig. 4.54. Installation of the special tool on the longitudinal lever of a suspension bracket
|
Install the special tool (09551-25000) on the longitudinal lever of a suspension bracket (fig. 4.54).
Take the plug of the longitudinal lever.
Fig. 4.55. A press fitting of the new plug in the longitudinal lever of a suspension bracket
|
By means of the special tool (09551-25000) press the new plug in the longitudinal lever of a suspension bracket (fig. 4.55).
Fig. 4.56. A plug arrangement concerning the lever
|
Replacement of the plug of the cross lever
Fig. 4.57. Installation of the special tool on the cross lever of a suspension bracket
|
Install the special tool (09545-28100 and 09545-25000) on the cross lever (fig. 4.57).
Take the plug of the cross lever.
Wet soap water of a surface of contact of the plug and cross lever.
By means of the special tool (09545-25000) press the new plug in the cross lever.
Replacement of the back stabilizer of cross stability
Disconnect stabilizer racks from a back rack of a suspension bracket.
Fig. 4.58. Removal of arms of fastening of the stabilizer
|
Remove arms of fastening of the stabilizer (fig. 4.58).
Remove the stabilizer of cross stability.
Check
Fig. 4.59. Check of the moment of rotation of the spherical hinge of a rack of the stabilizer
|
Check the moment of rotation of the spherical hinge of a rack of the stabilizer (fig. 4.59).
In the presence of cracks or ruptures of a protective cover of the spherical hinge replace it and add lubricant to the spherical hinge.
Several times shake a finger of the spherical hinge of a rack of the stabilizer.
Screw самоконтрящуюся a nut on a finger of the spherical hinge and then measure the moment of rotation of a finger.
Nominal rate: 3,5–4,0 N · m.
If the moment of rotation exceeds the top limit of nominal rate, replace a stabilizer rack.
If the moment of rotation is less than lower limit of nominal rate, then the spherical hinge is considered suitable for further operation while there is no jamming and an excessive gap in the hinge.