3.3.2. Check of chains of the switch of blocking of a starter (automatic transmission selector switch)

Fig. 3.48. Check of chains of the switch of blocking of a starter



Adjustment of the switch of blocking of a starter (automatic transmission selector switch) and cable of management of the automatic transmission

Fig. 3.49. Adjustment of the switch of blocking of a starter



Install the automatic transmission selector lever in situation "N".
Weaken an adjusting nut of fastening of a cable of management of the automatic transmission to the lever of manual control.
Install the lever of manual control (manual control lever) in neutral situation ("N").

Fig. 3.50. Bolts of fastening of the switch of blocking of a starter


Weaken bolts of fastening of the switch of blocking of a starter (the automatic transmission selector switch) and turn its case so that the opening in a flange of the case of the switch was combined with an opening on the end of the lever of manual control (manual control lever, section A-and in the figure 3.50
Without allowing change of position of the switch of blocking of a starter (the automatic transmission selector switch), tighten bolts of its fastening the nominal moment.

Fig. 3.51. Adjusting nut


Slightly pull the cable connecting the automatic transmission selector lever to the block of the operating valves in the direction specified by an arrow in the figure 3.51 and then tighten an adjusting nut.
Make sure that the lever of the automatic transmission selector is in situation "N".
Check compliance of the included transfers to each position of the lever of the automatic transmission selector and be convinced that the transmission works normally at each of ranges.