1.6.3. Systems of passive safety

The fastenings of shoulder straps of safety of front seats regulated on height

Fig. 1.116. Extraction of a seat belt



Height of fastening of a seat belt of a front seat can be adjusted in one of 4 provisions. If fastening of a seat belt is located too close to a neck, the belt will not be able to provide the maximum protection. A humeral part of a belt has to be adjusted so that it passed across a breast and in the middle of a shoulder, closest to a door. to adjust height of fastening of a belt, press heights of fastening of a seat belt the blocking button and move down or up fastening of a belt to desirable situation which provides dense contact of a belt with a shoulder. For fixing of fastening of a belt release the blocking button. After that try to move fastening of a seat belt down or up to be convinced that it is reliably recorded in this situation.

Fig. 1.117. Fastening of a seat belt



ATTENTION
Fastening of a seat belt has to be recorded during the movement of the car.
The wrong adjustment of height of fastening of a seat belt can reduce considerably its efficiency at accident.

Three-point seat belt of the driver with tightening and inertial mechanisms of blocking
To fasten a seat belt, extend it from the involving mechanism and insert a belt level (a latch uvula) to its lock before click. The seat belt automatically chooses the required length only after the zone belt is adjusted. You watch that the belt was correctly fastened and was not overwound.

Adjustment of a seat belt

Fig. 1.118. The correct provision of the fastened seat belt


Never put on a zone seat belt across an abdominal cavity. In case of accident the belt can sharply crash into a stomach and increase risk of getting injured. When the belt is located too highly, danger that the passenger will slip out from under a belt in case of the road accident (accident) or at sharp braking increases. It can lead to death or serious injuries. Both hands should not be at the same time under or over a belt. One hand has to be under, and another over a belt, as shown in the figure 1.118.
Never push a seat belt near at hand, located closer to a door.

Otstegivaniye of a seat belt

Fig. 1.119. Otstegivaniye of a seat belt



For an otstegivaniye of a seat belt undertake a level (a latch uvula) and press the button on the belt lock. When the belt is unfastened, it will be automatically will clean up back in the involving mechanism.
If it does not occur, check a belt for lack of twisting and repeat attempt again.

Seat belt with fastening in two points (the central seat belt of a back seat)

Fig. 1.120. Fastening of a back seat belt



To fasten a seat belt with fastening in two points, implant a uvula of a latch to the lock. Fixing of the lock is followed by characteristic click. Check reliability of fastening of the lock of a seat belt and be convinced that the belt is not overwound.

Adjustment of provision of a back seat belt

Fig. 1.121. Adjustment of provision of a back seat belt



When using a seat belt with fastening in two points, adjust its length so that it fitted a body tightly. Fasten a belt and slightly tighten it to eliminate sagging. A belt it is necessary to have as low as possible on hips. The high arrangement of a belt increases risk of getting injured in case of the road accident (accident).

Otstegivany back seat belt

Fig. 1.122. Otstegivany back seat belt



For an otstegivaniye of a seat belt undertake a level (a latch uvula) and press the button on the belt lock.

ATTENTION
The mechanism of fastening of a zone central seat belt of a back seat differs from mechanisms of shoulder straps of safety of a back seat. During fastening of shoulder straps or a zone central seat belt of a back seat be convinced that the necessary lock for receiving the maximum protection is used.