1.6.1. Adjustable seats

ATTENTION
You make adjustment of a seat only on the motionless car. Non-compliance with this rule can lead to loss of control over the car and the road accident (accident).

Adjustment of longitudinal provision of a front seat

Fig. 1.88. Adjustment of longitudinal provision of a front seat



To move a seat in longitudinal situation, lift the adjustment lever up. Thus the seat will be released, and it can be moved forward and back to a comfortable position. After installation release the lever of adjustment and slightly move a seat forward or back to record it in new situation.

Adjustment of an inclination of a seatback

Fig. 1.89. Adjustment of an inclination of a seatback



For an inclination of a seatback bend forward to remove the weight from a seatback and pull the lever of adjustment of an inclination of a seatback located from the outer side of a seat, up. Press a seatback and establish it in desirable situation. to record a seatback in new situation, release the lever of adjustment of its back.

ATTENTION
To reduce risk of developing of a trauma at the road accident (accident) or sharp braking at the movement of the car, seatbacks of the driver and the forward passenger have to be in the situation whenever possible close to vertical. Efficiency of protection of seat belts and inflatable safety cushions can be considerably reduced when the seatback is inclined.
There is a high probability of the fact that when the seatback is inclined, the driver and the forward passenger can slip out from under a seat belt that will entail receiving serious injuries at collision of the car during the road accident (accident).
The seat belt will not be able to provide full protection of the passenger when the back of his seat is inclined.

Adjustable head restraints

Fig. 1.90. Adjustment of a head restraint



Head restraints provide protection of area of a neck.
To lift a head restraint, pull it up. to lower a head restraint, press it down, at the same time pressing a clamp.

Adjustment lumbar a subtime (only for sitting of the driver) (the additional equipment)

Fig. 1.91. Adjustment lumbar subtime



For adjustment lumbar a subtime turn the special lever located on the outer or left side of a seatback of the driver. For increase in force of support move the lever of adjustment lumbar a subtime towards a forward part of the car. For weakening of force of support move the lever towards a back part of the car.

Adjustment of height of a pillow of a seat (only driver's seat) (additional equipment)

Fig. 1.92. Adjustment of height of a pillow of a seat



To lift or lower a forward part of a pillow of a seat, turn the forward handle forward or back. To lift or lower a back part of a pillow of a seat, turn the back handle forward or back.

Tray under a seat of the forward passenger

Fig. 1.93. A tray under a seat of the forward passenger


Under a seat of the forward passenger there is a tray (fig. 1.93).
That to open it, pull it forward.

Adjustment of longitudinal provision of a back seat

Fig. 1.94. Adjustment of longitudinal provision of a back seat



To move a seat in longitudinal situation, lift the adjustment lever up. Thus the seat to be released and it can be moved forward and back to necessary situation. After installation in a comfortable position release the lever of adjustment and slightly move a seat forward or back to record it in new situation.

Adjustment of an inclination of a back of a back seat

Fig. 1.95. Adjustment of longitudinal provision of a back seat



For an inclination of a seatback pull the lever of adjustment of an inclination of a seatback towards a head restraint and after installation of a back in desirable situation release the lever. After installation of a back of sitting in desirable situation always check reliability of its fixing.

Adjustable head restraints of back seats (additional equipment)

Fig. 1.96. Adjustment of head restraints of back seats



To lift a head restraint, pull it up. to lower a head restraint, press it down, at the same time pressing a clamp.

Folding of a pillow and back of a back seat

Fig. 1.97. Folding of a pillow and back of a back seat



For convenience the back and a pillow of back sitting can be put and spread out.
To put a seatback, move it to extreme back situation.
Remove head restraints.
To put a seatback, pull and hold the lever of adjustment of an inclination of a seatback towards a head restraint, and then lower a seatback down.

Fig. 1.98. Raising of a pillow and back of a back seat


Pull the seat pillow unblocking lever up, and then lift a pillow of a back seat (fig. 1.98) up.

ATTENTION
For prevention of damage of a coaster of the back seat located in the back console at first move away him, and then put a back and a pillow of a back seat.


Fig. 1.99. Fixing of a seat


For fixing of a seat fasten the loop for fastening located under a seat pillow to the holder of a head restraint of a seat of the driver and the forward passenger (fig. 1.99).
Insert the removed head restraints between a back and a pillow of a back seat so that. they were not thrown out in interior of the car in case of sharp braking or accident.
For return of a back and a pillow of a back seat to normal situation repeat the above-stated operations upside-down.
After return of a seatback to vertical position be convinced that it is reliably recorded, shaking a seatback for its top part forward and back.

ATTENTION
At return of a back of a back seat to vertical position after the seat was put, be careful, do not damage a tape or the lock of a seat belt. Besides, do not allow jamming of a tape or a uvula of a seat belt a back seat.
The pillow of back sitting developing forward and the back of back sitting inclined forward are intended to transport the bigger volume of baggage in the car. Do not allow anybody to sit on baggage during the movement of the car. When the back of a back seat is put use of seat belts is impossible. Incorrectly sitting and not fastened passengers can get heavy and even fatal injuries in case of sharp braking or the road accident. The transported baggage should not be located above backs of front seats. It can lead to baggage shift forward and to drawing severe injuries in case of sharp braking or the road accident (accident).
At return of a back of a back seat to vertical position after the seat was put, be convinced that head restraints are correctly recorded. Head restraints are important for safety of passengers of the car in case of the road accident (accident). If head restraints are not established in the correct situation, then at arrival receiving serious or even fatal injuries is behind possible.

Heating of front seats (additional equipment)

Fig. 1.100. Switches of heating of front seats



For trips to cold weather in the car there is a heating of front seats. When the engine works, press any of switches of heating of seats of the driver or the passenger. At moderate weather or in conditions, when there is no need for heating of seats, switches of heating of seats have to be in the provision of "OFF" ("Off").
Do not hold the lighter in completely drowned situation. It can lead to damage of a heating element and ignition. In case of need replacements of the lighter, use only the original lighter or similar.

Ashtrays

Fig. 1.101. Forward and back ashtrays



To open a forward ashtray, press also otpustitey the upper edge.
To take out an ashtray from a nest for cleaning, it is necessary to remove the metal collection of ashes. Press the collection of ashes down and forward in an ashtray then take out it. to put it into place, establish the collection of ashes in the correct situation and press it down and forward to record the lower edge of the collection of ashes in an ashtray. Illumination of an ashtray burns only at inclusion of external lighting of the car.

Forward coasters (additional equipment)

Fig. 1.102. Forward coasters



The coaster serves for keeping of glasses and bottles in the available openings.
To use a coaster for the forward passenger press a coaster and pull out outside.

ATTENTION
Do not place foreign objects on a coaster. They can be thrown out in interior of the car and injure passengers of the car at sharp braking or in case of the road accident (accident).

Back coaster (additional equipment)

Fig. 1.103. Back coasters



The back coaster is located on the back main console and serves for keeping of glasses and bottles in the available openings. to use, press the handle on the back main console down and pull out it for the upper edge.

ATTENTION
For prevention of damage of a coaster of the back seat located in the back console at first move away him, and then put a back and a pillow of a back seat. Return a coaster to a starting position if you do not use it.

Central armrest of a back seat (additional equipment)

Fig. 1.104. Central armrest of a back seat



This armrest is located in the center of a back of a back seat and has a ware box. Having opened a cover of a ware box, it is possible to use the coaster which is available in it.